Mr-Glass Roof Repair Nationwide | TruePane Windows & Doors

Mr-Glass Roof Repair in Coral Springs: What to Know First

Mr-Glass roof repair in Coral Springs typically runs $350 to $1,200 depending on the panel size, where the leak is, and whether we’re replacing glass or rebuilding the curb and flashing around it. Most Mr-Glass skylight and roof-glazing repairs take a single visit, and we’ll tell you honestly whether the roof glass can be saved or whether replacement is the cheaper long-term call. This page is for Coral Springs homeowners with a Mr-Glass skylight, roof window, or glass roof section that’s leaking, fogged, cracked, or letting water in around the frame. Call (727) 261-2215 and a live person answers, day or night.

Call (727) 261-2215

How Mr-Glass Products Fail - and How We Fix Them

Mr-Glass roof glazing has a few failure patterns we see repeatedly across Coral Springs. Here’s what actually goes wrong, and what we do about it.

• Weep-channel clogging on Mr-Glass curb-mounted skylights. The original Mr-Glass curb skylights rely on perimeter channels to carry condensation and minor seepage off the glass. In Coral Springs, oak pollen, dust from the Sawgrass Expressway corridor, and the wet-dry cycles of our rainy season turn those channels into packed sludge within a few years. The skylight isn’t leaking because the seal failed; it’s overflowing because the drain path is blocked. We clean the channels, verify the slope, and reseat the glass. That’s a $350 to $500 repair most of the time, versus a $1,400 replacement quote someone else might hand you.
• Exterior gasket decompression on Mr-Glass flat glass roof panels. Flat roof glass sections set in aluminum bar framing use compression gaskets to keep water out. After ten or fifteen years of Coral Springs sun exposure, those EPDM gaskets flatten out and lose their spring. Water gets in around the glass edge, not through it. We replace the gaskets with a current-generation compound rated for Florida UV exposure, re-set the panel, and the leak stops without touching the glass itself. This is one we fix often for homeowners in Cypress Glen and Maplewood who were told they needed a whole new roof-light section.
• Fogging between Mr-Glass insulated glass layers. Mr-Glass insulated units on roof applications fail faster in South Florida than in cooler climates because the constant heat stress on the edge seal causes the desiccant inside the spacer to saturate early. Once you see fog between the panes that doesn’t clear by midday, the unit is done. We measure the rough opening, order a matching insulated glass unit, and install it with the same edge-seal method Mr-Glass used originally, so the replacement lasts as long as it should. Repairing the seal on a failed unit isn’t something we offer, and here’s why: we won’t warranty a patch on glass that’s already let moisture into its core.
• Flashing separation where Mr-Glass roof units meet barrel tile. Coral Springs homes with barrel tile roofs put a lot of stress on any roof penetration. Mr-Glass units flashed for composition shingle get re-flashed for tile by whichever roofer showed up that week, and the results vary. We see gaps where the tile was cut too wide around the skylight and the exposed flashing starts lifting after a few storm seasons. We strip back the tile, rebuild the flashing to the Mr-Glass curb dimensions, and re-bed the tile. That’s a repair where the difference between a $500 fix and a $2,000 re-do is whether the person on the roof actually understands how tile sheds water.
• Cracked or impact-damaged Mr-Glass roof glass from storm debris. Coral Springs sits in a windborne-debris region, and roof glass takes the worst of it. A cracked Mr-Glass panel usually means replacing the glass unit, not patching it, because the structural integrity of a fractured panel can’t be restored. We’ll measure it on the first visit, order the replacement to match the original glass type, and tarp the opening properly until the new unit arrives. You won’t sit with a blue tarp for six weeks; we order the same week we measure.

Our Mr-Glass Roof Repair Process

Every Mr-Glass job follows the same sequence, and we don’t skip steps.

1. 1
   The call. You call (727) 261-2215. A live person answers, takes the address and the symptom, and schedules the visit. No voicemail tree.
2. 2
   The roof inspection. We go up, pull back the tile or shingle around the unit where needed, and find the real source. We read the rough opening before we quote anything.
3. 3
   The written quote. We put line-item pricing on paper, including parts, labor, and any tile or flashing work. No change orders hiding behind the first number.
4. 4
   The part decision. If the glass, gasket, or hardware can be matched to Mr-Glass OEM spec, we use it. If a current-generation aftermarket part is genuinely better for Florida exposure, we tell you and put both options on the quote.
5. 5
   The repair. Uniformed, background-checked technicians do the work. One visit for most repairs.
6. 6
   The water test and the warranty. We run water over the repair before we come down off the roof. Then we register the glass manufacturer warranty in writing and hand you the TruePane Done Right Promise before the truck leaves the driveway.

What Mr-Glass Roof Repair Costs in Coral Springs

Repair pricing in Coral Springs runs a little different from the national numbers because of roof type and UV stress on the materials. These are the ranges we quote most often.

• Weep-channel cleaning, reseat, and seal on a curb-mounted Mr-Glass skylight: $350 to $500
• Exterior gasket replacement on a Mr-Glass flat roof panel: $450 to $700
• Flashing rebuild and re-tile around a Mr-Glass roof unit: $500 to $1,200
• Insulated glass unit replacement for a fogged Mr-Glass skylight: $600 to $1,400
• Full Mr-Glass skylight replacement, including curb and tile work: $1,200 to $2,800

What moves the price is glass size, roof type, tile repairs, and whether the curb under the skylight has dry rot. We pull the flashing and look before we quote, so the number you get is the number you pay. Call (727) 261-2215 for a free estimate, and mention you’re a senior or veteran if it applies; there’s a standing 5% discount we don’t advertise much but honor every time.

Why Coral Springs Homeowners Call TruePane Windows & Doors for Mr-Glass Work

We’re an independent Mr-Glass service provider, not a franchise, and we didn’t start doing roof repair because a marketing firm told us to. We started because Coral Springs homes from the 1980s and 1990s have a lot of Mr-Glass roof glazing, and those units are all hitting the same age. Dale Kessler grew up in Ramblewood watching his father re-seal jalousie windows against every summer storm off the Everglades, and the lesson stuck: a bad seal costs you more than a good one ever would. If a Mr-Glass unit isn’t worth saving, we’ll tell you that, and we’ll quote PGT, CGI, CWS, or ES Windows replacements side by side on paper so you know the real spread. We stand behind the work with a Done Right Promise and both warranty layers registered in writing before the truck leaves the driveway. Measure it right the first time, and the rest of the job takes care of itself.

FAQs