Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterViewLux Roof Replacement & Installation in Coral Springs: What to Know First
We provide independent ViewLux roof replacement and installation in Coral Springs, typically completing a standard skylight replacement in one visit and a full roof-window system in two to three days once parts arrive. Pricing runs honest: we quote the job after reading the opening and the roof deck, not before, so the number on your written estimate is the number you pay. If you own a ViewLux unit that’s failing, call (727) 261-2215 and a live person will answer.
This page is for Coral Springs homeowners who already have ViewLux skylights or roof windows and need straight answers about replacement, installation, parts, and cost. We are not the manufacturer and we don’t pretend to be. We are an independent ViewLux service provider with four decades of glazing experience behind every job we take on.
How ViewLux Products Fail - and How We Fix Them
- ViewLux Acrylic Dome Skylights: flange seal breakdown at the curb. In Coral Springs, the combination of intense UV exposure and afternoon thunderstorm cycles causes the butyl seal between the dome frame and the curb to dry out and lift. Water then wicks underneath and tracks along the drywall seams well away from the opening, which is why owners often mistake a flashing leak for a plumbing problem. We remove the old dome, inspect the curb for rot, re-flash with new butyl and aluminum, and set the replacement dome with a positive lap on all four sides. If the curb itself is compromised, we rebuild it before anything else goes back on.
- ViewLux Venting Skylights: operator arm and motor corrosion. The venting units sold in South Florida through the late 2000s used a zinc-plated steel operator arm that does not hold up against coastal humidity drift from the Everglades. The arm rusts, the motor strains, and the unit either won’t open or won’t seal when closed. We replace the operator assembly and, where the original control board has failed, we source a compatible control that does not require rewiring the whole chase. The fix is usually far less expensive than full replacement, and we will tell you that plainly.
- ViewLux Glass Roof Windows: interior gasket compression set. The interior gasket on older ViewLux glass roof windows compresses over time, especially on west-facing slopes that get the full afternoon sun. Once the gasket loses its memory, the glass panel shifts slightly and the unit starts to draft or rattle in wind. We replace the gasket with a profile matched to the original extrusion, not a generic roll that fits loosely, then reset the panel and confirm the reveal is even on all four sides.
- ViewLux Sun Tunnels: condensation between the tube and the ceiling ring. Sun tunnels in Coral Springs attics pick up warm moist air from the attic space, and if the ceiling ring was never sealed properly to the ceiling drywall, that moisture condenses on the metal and drips back down around the trim. Owners see a slow water stain around the ring and assume the roof is leaking. Usually it is not. We seal the ceiling ring from below, add insulation at the attic side, and where the tube itself has separated at a joint, we re-tape and re-band it so the air path is closed.
- ViewLux Curb-Mount Flat Glass Units: glass seal failure at the edge. Flat glass ViewLux roof windows installed on low-slope flat roofs in Coral Springs are vulnerable to edge-seal failure because standing water sits against the frame longer than it does on a pitched roof. Once the inert gas escapes and moisture gets between the panes, the glass fogs permanently. We measure the existing sash, order a replacement insulated glazing unit with the correct overall thickness, and set it into the existing frame if the frame is still sound. That saves the cost of a full curb replacement and keeps the job to a single day.
Our ViewLux Roof Replacement & Installation Process
- 1
Call and describe the problem. You will talk to a person, not a phone tree. We ask about the roof pitch, the age of the unit, and what you are seeing from inside the house.
- 2
We read the opening and the roof before quoting. Dale Kessler rarely quotes a ViewLux job without getting on the roof or into the attic first. We measure the rough opening, check the curb condition, and look at how the flashing was originally installed. Measure it right the first time, and the rest of the job takes care of itself.
- 3
Parts decision on paper. For each ViewLux unit we tell you what is available OEM, what a quality aftermarket equivalent costs, and what the trade-offs are. You decide with the numbers in front of you.
- 4
Replacement and re-flashing. We remove the old unit, repair or rebuild any curb or deck damage, set the new unit, and flash it to Coral Springs code so water moves off the roof and away from the opening.
- 5
Interior finish. We re-trim the shaft if needed, replace any drywall that had water damage, and check the operation from below. If it vents, we cycle it a half dozen times.
- 6
Guarantee in writing. Both warranty layers registered in writing, durations stated, and the Done Right Promise covering the workmanship before the truck leaves your driveway.
What ViewLux Roof Replacement & Installation Costs in Coral Springs
- Acrylic dome skylight replacement (24×48): $650-$1,100 installed, including new flashing and curb inspection
- Venting skylight motor and operator replacement: $280-$520 depending on control compatibility
- Flat glass roof window insulated glazing replacement: $400-$850 for the glazing unit set into an existing frame
- Sun tunnel re-seal with attic insulation: $180-$320 depending on attic access
- Full curb rebuild and skylight replacement: $1,200-$2,400 when the curb framing has rot from a long-term leak
What moves the price is roof access, the condition of the curb, and whether the unit is still in production. ViewLux discontinued several skylight lines, and discontinued parts are often more expensive to source than current ones. We also carry no surprise line items: if unexpected rot or structural work shows up, we stop and show you what we found with a written quote before any additional work starts. Call (727) 261-2215 for a free estimate on your specific ViewLux unit.
Why Coral Springs Homeowners Call TruePane Windows & Doors for ViewLux Work
We have been keeping glass work true in South Florida since 2008, and Coral Springs is where Dale Kessler grew up, back in Ramblewood, where his father spent weekends resealing jalousie windows against summer storms. That is not a marketing line; it is the reason the company exists. When you call us for ViewLux work, you get a background-checked, uniformed technician who measures twice and tells you what the unit needs and what it does not need. Every job is covered by the Done Right Promise, and we register both manufacturer warranty layers in writing before we leave. If the unit cannot be saved or parts are gone, we can quote replacement lines side by side on paper, including PGT, CGI, CWS, and ES Windows, so you always know exactly what you are buying and what it costs. A live person answers the phone 24 hours a day, and we stand behind every install we put our name on.
FAQs
Most ViewLux roof replacements run between $650 and $2,400 in Coral Springs depending on unit type, roof access, and whether the curb needs rebuilding. Acrylic dome replacements are the most affordable, while full curb rebuilds on flat roof installations are at the top of the range. Call (727) 261-2215 for an exact quote. Estimates are free.
Most acrylic dome replacements and motor repairs can be completed in a single visit if the parts are on the truck or available locally. Full glass roof window replacements with custom glazing may take a few days for the unit to arrive. Call us to schedule a diagnostic and we will tell you the realistic timeline for your specific unit.
The quote is a fixed price unless we open the roof and find structural damage that could not be seen from the surface. If that happens, we stop work, show you the problem, and give you a written quote for the additional repair before we proceed. No surprise line items. No change orders slipped into the final bill.
Where the city of Coral Springs requires a permit for roof opening or re-flashing work, we pull it and close it out with an inspection. If the job is a direct replacement with no structural change, permits are often not required. We will tell you which category your job falls into on the first call.
Replacing a failed part with an OEM or equivalent aftermarket component on the frame itself typically does not void the unit warranty, but altering the flashing or the curb without proper workmanship can. We photograph every step, document everything in writing, and register any manufacturer warranty on replacement parts so your coverage stays intact. As an independent service provider, we work alongside your ViewLux warranty terms rather than against them.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Coral Springs and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.