Door Installation in Lighthouse Point - Free In-Home Measure, Written Price

Fast, Reliable Door Installation Across Lighthouse Point

A standard door installation in Lighthouse Point runs $1,200 to $4,800 for most entry and French door replacements, while custom pivot or arched canal-front units typically fall between $5,500 and $14,000 depending on rough-opening resizing and impact-rating requirements. We’re TruePane Windows & Doors, and we’ve been setting doors square in Broward County’s canal neighborhoods long enough to know what the salt air does to hardware and what the HVHZ code requires before the permit is ever pulled. If you’re replacing a corroded slider on the C-10 canal or reframing a jalousie door on a 1960s ranch off NE 28th Street, call (727) 261-2215 and we’ll give you an honest read on scope before we quote a dollar.

Call (727) 261-2215

Lighthouse Point is different from every inland Broward city we work in. Your lots sit on saltwater. Your prevailing wind comes off the Atlantic two miles east. Your inspectors enforce Miami-Dade NOA impact standards on every opening. We know that. It changes how we size the rough opening, which fasteners we spec, and which Door Installation methods survive a full hurricane season without callbacks. Nobody wants a door that binds in July or a threshold that weeps salt by December. We build for the site, not the catalog.

Why TruePane Windows & Doors Is Lighthouse Point’s Preferred Door Installation Company

We’re a second-generation glazier’s shop, founded by Dale Kessler in 2008, and we still operate on the rule he wrote on the board: if the pane is not true, the job is not done. That means every door we set in Lighthouse Point gets measured twice, shimmed level and plumb, and checked for square before the casing goes on. We don’t rush a threshold in a canal-front home and we don’t leave a homeowner to figure out why a double French door binds when the humidity climbs.

Our crews work in Lighthouse Point regularly, from the C-1 canal east to Federal Highway and the neighborhoods around Venetian Isles. We’ve replaced originals on 1950s ranches off NE 31st Court, retrofitted impact units on split-levels near the Hillsboro Inlet, and rebuilt rotted rough openings on canal-side lanais where salt had eaten the bottom six inches of the jamb. Homeowners here have told us the same thing for years: they want a company that answers the phone, shows up uniformed, and doesn’t disappear after the final invoice. That’s what we do. Dale still answers calls personally, and a live person picks up at (727) 261-2215 any hour, any day.

Every job carries The Keystone Standard. Both manufacturer warranty layers are registered in writing before our truck leaves your driveway. You get the Done Right Promise on workmanship. No paperwork fights, no arguing, no fine print that covers neither. That’s our square deal, and it’s why homeowners in Lighthouse Point keep our number in their Rolodex.

Our Door Installation Services in Lighthouse Point

We don’t sell doors from a brochure. We walk the opening, look at the exposure, check what the salt has done to the existing frame, and then quote manufacturer lines side by side on paper. Here’s what we install most often on Lighthouse Point lots.

Double & French Doors

Double French doors are the standard replacement for aging sliders on canal-front lanais and Florida rooms throughout Lighthouse Point. These openings usually require the most reframing because the original aluminum sliders were set in rough openings that are too narrow for two active panels rated to HVHZ wind loads. A typical double French door replacement in Lighthouse Point runs $3,200 to $7,800 when we’re reframing, flashing, and pulling the permit. On a 1960s ranch off NE 31st Court, we pulled a corroded slider that had gone completely through at the sill corners. The jamb was so degraded we rebuilt the entire rough opening with pressure-treated lumber, new flashing tape, and a Miami-Dade NOA Andersen French door with fusion-welded frame. That’s what passing Broward County inspection looks like in the field.

Pivot Doors

Pivot doors are heavy. On Lighthouse Point canal-front homes with wide entry halls and elevated slabs, a custom pivot unit with concealed floor hinges and multi-point locking typically starts around $6,500 and can reach $14,000 for oversized heights or custom veneers. The pivot system puts all the load on the top and bottom hardware, so we spec marine-grade stainless components from the first quote. Cheap interior hardware on a pivot door exposed to canal air will sag within two seasons. We won’t bid it that way.

Entry & Swing Doors

Standard entry door replacement in Lighthouse Point runs $1,200 to $4,800, with impact-rated fiberglass or steel units at the upper end. For front doors on NE 26th Avenue or along Sample Road, the bigger question is usually the rough opening. Many of these homes were built when a 32-inch door was the norm. If you want a 36-inch impact-rated door with a proper threshold, we may need to widen the opening and re-trim the casing. We scope that before quoting, not after demolition starts.

Bifold & Folding Doors

Bifold and folding door systems are a common upgrade for canal-side great rooms where homeowners want the entire rear wall to open to the patio. In Lighthouse Point, these jobs almost always involve structural header work and HVHZ-rated panels that run $850 to $1,400 per linear foot, installed. The folding hardware stack on the interior side, and with salt air moving through the opening year-round, we use only marine-rated track and roller components. We also verify the slab is level across the entire span. Older canal homes settle, and a quarter-inch dip over eighteen feet turns a folding door into a bind-and-scrape problem.

Trusted Brands We Service in Lighthouse Point

We’re factory-authorized for PGT, and we service and install nearly every major line on the market including and Ply Gem. What that means for Lighthouse Point homeowners is straightforward: if you bought a PGT impact door for your canal-front home, we know the product line, we stock the replacement hardware, and we can register both warranty layers correctly the first time. We don’t file the paperwork weeks later. It’s done before we leave. If you need an Andersen or Pella unit serviced, we handle those too, with side-by-side quotes on paper so you see exactly what you’re buying.

Common Door Installation Problems We See in Lighthouse Point Homes

We’ve worked enough canal lots to know what fails and why. Here are the problems that come up most often.

• Salt-ruined fasteners and hardware. Canalside homes in Lighthouse Point sit in a persistent salt-laden microclimate that moves with the Atlantic onshore wind. Standard interior-grade screws on an entry door will corrode through in two seasons. We see hinge screws that snap at the plate and lock mechanisms that seize. Every fastener we use on a canal-side opening is marine-grade stainless or it doesn’t go on the truck.
• Original jalousie and louvered doors. These are everywhere on older Lighthouse Point Florida rooms. The frames were never built to modern impact unit dimensions, so a direct swap is rarely possible. The rough opening must be resized, reframed, and re-flashed before a fixed or casement HVHZ unit fits properly. Insurers and Broward inspectors flag these openings immediately.
• Undersized rough openings for impact-rated units. Impact doors are heavier and thicker than the thin aluminum sliders they replace. When a contractor tries to force an HVHZ door into a narrow original opening, the gaps are uneven, air leaks through the jamb, and the wind-load test fails. We measure twice and often rebuild the opening once.
• Canal water evaporation and threshold corrosion. The constant moisture from canal evaporation keeps aluminum thresholds wet. Older thresholds on herringbone-pattern canal lots near the C-9 and C-10 waterways often rot out at the corners. We replace them with composite or stainless thresholds that don’t wick salt water into the framing.

Pricing for Door Installation in Lighthouse Point, FL

We Also Serve Cities Near Lighthouse Point

Our crews work the full corridor from Lighthouse Point south and west into Coral Springs, Margate, Parkland, and Tamarac. We know the code differences between Broward’s inland communities and the canal zone, and we price each job for the actual site conditions. If you’re a few blocks off the water in Margate, you’re not paying Lighthouse Point salt-air pricing. And if you’re on a C-10 canal lot, we’re not quoting inland hardware. We’ll be there when we say.

FAQs - Door Installation in Lighthouse Point