Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterMr-Glass Roof Replacement & Installation in Coral Springs: What to Know First
We provide independent Mr-Glass roof replacement and installation in Coral Springs, with most jobs completed in one visit and pricing that’s written down before we start. A typical Mr-Glass roof panel replacement runs $600 to $1,900 depending on the series, the size of the opening, and whether the original frame can be salvaged. We’re an independent Mr-Glass service provider, not a factory affiliate, which means we quote what the job actually needs, not what a warranty department tells us to sell. This page is for Coral Springs homeowners with a Mr-Glass skylight, roof window, or glass roof section that’s leaking, fogged, cracked, or just past its useful life. Call (727) 261-2215 and a live person answers.
How Mr-Glass Products Fail - and How We Fix Them
- Seal failure around the curb-mount frame on Mr-Glass CM Series skylights. In Coral Springs, the real culprit is usually the original flashing installed against the roof deck, not the glass itself. Our fix: we pull the old curb flashing, inspect the deck for rot, install new peel-and-stick membrane before the frame goes back, and set the glass on fresh gaskets. The seal gets tested with a hose before we leave.
- Stress cracks running from the corners of Mr-Glass TG Series tempered panels. These show up when the original installers shimmed the frame against a roof joist instead of floating it. A roof moves, and a rigid-mounted panel takes that movement at the corners. We reset the frame with proper clearance, replace the panel with OEM-spec tempered glass, and the crack doesn’t come back.
- Condensation between the panes on Mr-Glass insulated roof units. This is the same failure you get in a fogged window: the desiccant strip in the spacer has gone, and the argon fill is gone with it. You can’t clean it off from the inside. The panel gets replaced as a sealed unit, and we register the new glass warranty in writing before the truck leaves.
- Leaking at the glazing bead on older Mr-Glass VL Series venting roof windows. The factory bead cracks with age and sun, especially on south-facing Coral Springs exposures. We replace the bead with a compatible profile and check the operator linkage for wear, because a venting unit that’s hard to close gets left half-open, and a half-open roof window leaks.
- Hail damage on Mr-Glass single-glazed roof panels in the Hillsboro Pines and Maplewood neighborhoods. Coral Springs gets its share of summer storms, and a cracked single-glaze panel is a liability waiting for the next heavy rain. We carry laminated replacement glass for these openings, which gives you a safety layer and meets current code for overhead glazing.
Our Mr-Glass Roof Replacement & Installation Process
Here’s how a Mr-Glass roof job runs with us, from first call to cleanup:
- 1
You call, a person answers. We ask about the opening, the age of the unit, and what you’re seeing. We’ll schedule a time that works for you.
- 2
We measure the rough opening. Dale Kessler reads every opening before he quotes it. That’s why our change orders are rare.
- 3
You get a written quote on paper. We show you the OEM option and any quality-comparable alternative, side by side, with prices.
- 4
We do the work. Old unit out, deck inspected, new flashing and frame set properly, new glass seated and sealed.
- 5
We test and document. Water test, hardware check, and both warranty layers registered in writing.
- 6
We clean up and walk you through it. What we did, what to watch for, what’s covered. The Done Right Promise applies.
What Mr-Glass Roof Replacement & Installation Costs in Coral Springs
Here’s what we’re seeing for Mr-Glass work in Coral Springs right now:
- Single-glazed Mr-Glass roof panel replacement: $600 to $900 installed, depending on access and opening size.
- Insulated Mr-Glass roof unit (fogged or failed seal): $1,100 to $1,900 installed, including new gaskets and flashing inspection.
- Flashing repair without glass replacement: $250 to $500, if the deck is sound and the original unit is intact.
- Full curb-mount skylight replacement (Mr-Glass to code-compliant laminated unit): $1,400 to $2,200, with new flashing membrane included.
What moves the price: roof pitch and access, the age of the original installation, any deck rot we find under the old flashing, and whether the frame can be preserved or has to go. We quote it all in writing before we start. Call (727) 261-2215 for a free estimate on your specific opening.
Why Coral Springs Homeowners Call TruePane Windows & Doors for Mr-Glass Work
We’ve served Broward County homeowners since 2008, and when a Mr-Glass roof fails, our techs know what they’re looking at before the ladder goes up. We don’t just swap glass; we diagnose the reason it failed the first time. Every job is covered by the Done Right Promise, and The Keystone Standard means both warranty layers are registered in writing before we leave your driveway. If your Mr-Glass unit is beyond saving, we can quote a replacement in PGT, CGI, CWS, or ES Windows, because we’re an authorized installer for more than a dozen manufacturer lines. And if something isn’t right after we leave, you call the same number, and a person answers the phone, 24/7. If the pane is not true, the job is not done.
FAQs
No. We provide independent Mr-Glass roof replacement and installation in Coral Springs, and we source parts from multiple suppliers to get you the best value. Our workmanship guarantee covers the job regardless of manufacturer authorization, and we register the replacement glass warranty with the manufacturer in writing.
In most cases, yes. We match the original glass specification, including low-E coatings and tint, using OEM or OEM-equivalent insulated units. If the original series is discontinued, we’ll show you the closest available match on paper before ordering anything. Call (727) 261-2215 and we’ll tell you what your options are for your specific unit.
Most single-panel Mr-Glass replacements are done in one visit, typically 2 to 4 hours depending on access and whether any deck work is needed under the old flashing. We clean up completely and test the seal before we leave.
Rarely. We measure the rough opening before we quote, and we inspect for deck rot as part of the estimate when access allows. The only time a number changes is if we find structural damage under the old flashing that could not have been seen before, and if that happens, we stop and show you what we found before doing anything else. Measure it right the first time, and the rest of the job takes care of itself.
We do both. A bad flashing job can leak around a perfectly good panel, and replacing the glass won’t fix that. We’ll diagnose the actual source of the water and quote only what’s needed, whether that’s the seal, the flashing, or the panel itself. Estimates are free, so call (727) 261-2215 and we’ll take a look.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Coral Springs and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.