Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterPly Gem Sliding & Patio Doors in Coral Springs: What to Know First
We provide independent Ply Gem sliding and patio door repair, parts replacement, and full door installation across Coral Springs, with most service calls completed in a single visit. Typical repair work on a Ply Gem slider runs between $180 and $450 depending on what failed, while full patio door replacement with a new Ply Gem or comparable line usually starts around $1,400 installed. We’re not affiliated with Ply Gem or authorized by them, which means we answer to you, not a manufacturer’s margin. Call (727) 261-2215 when a Ply Gem door starts sticking, leaking, or refusing to lock.
This page is written for the Coral Springs homeowner who owns a Ply Gem sliding door and wants to know whether to repair or replace it, what it costs, and who can do it without voiding whatever warranty remains. Dale Kessler reads every rough opening before we quote it, and our techs register warranty layers in writing before the truck leaves your driveway.
How Ply Gem Products Fail and How We Fix Them
- Roller assembly collapse on 8400 Series sliders. The original nylon rollers Ply Gem used in many 8400 Series patio doors get brittle after seven to ten years of Florida heat and humidity. The symptom is a door that suddenly drags hardest in the middle of the track, or a track that starts gouging. We replace the rollers with sealed stainless-bearing units rated for coastal air, not the soft nylon repeat that will fail the same way in five years.
- Vinyl frame bow at the latch side on wide 5600 Series sliders. Coral Springs sun loads the west-facing elevations all afternoon. On wide openings, the vinyl stile can bow enough that the hook latch misses the keeper. Ply Gem frames are not bad, but they need adjustment shims at installation that many original builders skipped. We re-shim, re-square, and set the striker so the door locks with one hand.
- Weep hole blockage from pollen and construction dust. Every Ply Gem sliding door drains water through weep slots at the base of the outer track. In Coral Springs, live oak pollen and dry season dust pack those slots solid within a couple of years. The door still slides, but the track holds water and the interior floor shows a dark stain. We clear the weeps, flush the track channels, and verify drainage with a controlled water test before we call it done.
- Intermittent lock failure from track gunk under the hook latch. Locks that work sometimes and not others are rarely the lock itself. Crud builds up under the keeper on Ply Gem sliders and prevents the hook from seating fully. We pull the keeper, clean the recess, and if the spring in the handle set has gone soft from ten years of Coral Springs humidity, we replace the handle set with an OEM Ply Gem part so the key still matches.
- Fogging between panes on Ply Gem insulated glass units. A seal fails and moisture works in, same as any brand. But Ply Gem dual-pane sliders in Florida homes often fail at the lower corner, where afternoon thunderstorm water sits against a hot track. We order the replacement IGU to the exact size and glass spec, and we handle the glass package only after measuring twice; a replacement unit that arrives one-eighth inch off costs you a second trip and another week with a clouded view.
Our Ply Gem Sliding & Patio Doors Process
- 1
Call and describe the symptom. A live person answers at (727) 261-2215. Tell us the door drags, sticks, won’t lock, or leaks. We’ll ask the age of the door and which side of the house it’s on.
- 2
On-site inspection and measurement. A uniformed, background-checked tech measures the opening and the panel before quoting anything. On Ply Gem work, we check the track for wear and the stiles for bow. Measure it right the first time, and the rest of the job takes care of itself.
- 3
Parts decision on paper. If the door needs parts, we present OEM Ply Gem and quality aftermarket options side by side, with prices and the trade-off of each. You decide; nobody gets talked into a part you didn’t choose.
- 4
The repair or replacement. We handle everything from roller and handle-set swaps to full-door replacements, including haul-off of the old unit. Most Ply Gem repairs are done in one visit.
- 5
Function test and warranty registration. We run the door through twenty open-close cycles, test the lock, and water-test the track. Before we leave, both manufacturer warranty layers get registered in writing with durations stated.
- 6
Done Right Promise. If anything we touched falters within 90 days, we come back and make it right. No paperwork, no arguing.
What Ply Gem Sliding & Patio Doors Costs in Coral Springs
| Job | Typical Coral Springs Range |
|---|---|
| Roller replacement (both panels, parts included) | $180 - $320 |
| Handle set or lock replacement (OEM Ply Gem) | $140 - $260 |
| Track cleaning, weep clearing, adjustment | $120 - $200 |
| Insulated glass unit replacement | $350 - $700 depending on glass size and coating |
| Full Ply Gem slider replacement (installed) | $1,400 - $2,600 depending on opening width and glass package |
What moves the price is usually the glass. A plain clear IGU costs less than a Low-E coated unit, and a six-foot door costs less than an eight-foot one. There are no surprise line items; the quote you approve is the bill you pay. We offer a permanent 5% discount for seniors and veterans, and right now we have a free written repair estimate. Call (727) 261-2215 for an exact quote. Estimates are free.
Why Coral Springs Homeowners Call TruePane Windows & Doors for Ply Gem Work
Because the door gets done right the first time, and if it doesn’t, we stand behind it. We’ve been serving Coral Springs and Broward County since 2008, and Dale Kessler founded TruePane in 2008 out of a simple rule: if the pane is not true, the job is not done. Our techs know Ply Gem door hardware by feel, but we’re also authorized installers for more than a dozen other lines, including, and PGT. That matters when you’d rather compare a Ply Gem replacement against another manufacturer than take whoever shows up first. A live person answers the phone 24/7, and we show up when we say. That’s a square deal.
FAQs
No, as an independent Ply Gem service provider, we repair doors without voiding manufacturer warranty coverage that remains in effect. We register both manufacturer warranty layers in writing before we leave, with durations stated, so you have a record of what’s covered and for how long. Call (727) 261-2215 to find out what your Ply Gem warranty still covers.
We get both. For hardware that touches your lock and key, like handle sets and cylinders, we stock OEM Ply Gem parts so the keyway still matches. For wear items like rollers, we recommend sealed stainless-bearing aftermarket units that hold up better in Coral Springs humidity than the original nylon. We put both options on paper and let you pick.
Repair makes sense when the frame is square and the glass is clear; replacement makes sense when the glass is fogged, the frame is bowed, or the track is worn to a knife edge. The threshold is usually around $700 in repair work. At that point, a new door with new rollers, new glass, and a fresh warranty is the better money. Call (727) 261-2215 and we’ll measure before we quote, so you get a real number either way.
Most repair calls are scheduled within a few days, and a live person answers the phone 24 hours a day, 7 days a week to get you on the schedule. Most Ply Gem roller, lock, and track repairs are completed in a single visit. Call (727) 261-2215 to get on the schedule before the weekend.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Coral Springs and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.